◎ 型號含義 Type meaning
① 電位器 Potentiometer (470K) (680K) （820K）
② 10A,25A,40A,60A,80A,100A,120A
◎ 產品概述 Product overview
◆ 額定電流：10A-120Amps
◆ 額定電壓：0-220VAC,0-380VAC,0-480VAC
◆ " 超低 " 的輸入電流
◆ 低輸出斷態漏電流
◆ 低輸出通態壓降
◆ 包含標準輸出的 R-C 緩沖器
◆ 控制方式全兼容，便于計算機連網調壓
◆ Rated current:10A-120Amps
◆ Rated voltage: 0-220VAC,0-380VAC,0-480VAC
◆ "Ultra low" input current
◆ Low output off-state leakage current
◆ Low output on-state voltage drop
◆ Standard output R-C buffer
◆ Fully compatible with different control methods, allowing the computer to easily adjust voltage through the network
注意 :
1. 當負載電流為 10A 時 , 必須加裝散熱器 ; 為 40A 及以上時 , 必須加風扇強冷或水冷 .
2. 使用感性負載時 , 務必在輸出端并接一個壓敏電阻 , 取值為負載電壓的 1.6-1.9 倍 .
Notice:
1. If the load current is 10A, a heat sink must be equipped; if the load current is 40A or more, an air-cooled radiator or a water-cooled radiator must be installed.
2. When the load is an inductive load, be sure to connect a varistor in parallel with the output terminal, whose voltage value is 1.6-1.9 times the load voltage.
◎ 安裝尺寸及接線圖 Installation dimensions and wiring diagram
注意：電位器端帶電
Attention: Terminals of the potentiometer is charged!
