◎ 型號含義 Type meaning
① 控制電壓 10-32VDC Control voltage 10-32VDC
② 直流換相 DC Commutator
③ 10A-40A
④ 負載 電壓 200VDC Load voltage 200VDC
◎ 產品概述 Product overview
◆ 額定電流：10A-100Amps
◆ 額定電壓：200VDC
◆ 低阻抗 MOSFET 輸出，最大限度減少總功耗
◆ " 超低 " 的輸入電流
◆ 低輸出斷態漏電流
◆ 低輸出通態壓降
◆ 具有 LED 燈 ( 紅 )（綠）雙色輸出指示
◆ 保護性正 / 反向內置聯鎖功能
◆ Rated current: 10A-100Amps
◆ Rated voltage: 200VDC
◆ Low-impedance MOSFET as the output component minimize the total power consumption
◆ "Ultra low" input current
◆ Low output off-state leakage current
◆ Low output on-state voltage drop
◆ Two color (Red & Green) LED output status
◆ Built-in forward/reverse interlock protection function
注意 :
1. 當負載電流為 10A 時 , 必須加裝散熱器 ; 為 40A 及以上時 , 必須加風扇強冷或水冷 .
2. 使用感性負載時 , 務必在輸出端并接一個壓敏電阻 , 取值為負載電壓的 1.6-1.9 倍 .
Notice:
1. If the load current is 10A, a heat sink must be equipped; if the load current is 40A or more, an air-cooled radiator or a water-cooled radiator must be installed.
2. When the load is an inductive load, be sure to connect a varistor in parallel with the output terminal, whose voltage value is 1.6-1.9 times the load voltage.
◎ 安裝尺寸及接線圖 Installation dimensions and wiring diagram
